SPSolve ProductionPractical production help from Lancing UK
feeding and presentation

How do I feed and present robotic pick and place reliably?

Stable production needs controlled orientation, spacing, buffering and handover to the next machine at a rate above normal demand.

Recommended machinery for this problem
packagingautomationuk.co.uk
View suitable machinery at packagingautomationuk.co.uk →

Direct answer

Stable production needs controlled orientation, spacing, buffering and handover to the next machine at a rate above normal demand. For robotic pick and place, confirm the result with representative product and packaging before altering several variables at once.

Likely causes

  • Bulk parts nest, tangle or segregate in the robotic pick and place process.
  • Buffer capacity is below normal demand in the robotic pick and place process.
  • The downstream interface is unstable in the robotic pick and place process.
  • Static, oil, dust or coating changes behaviour in the robotic pick and place process.

What should be checked first?

  • Provide representative samples
  • Define required orientation and handover
  • Measure sustained feeder output
  • Allow for rejects and recirculation
  • Test material and dimensional variants
  • Verify buffer recovery
  • Connect to a realistic downstream load

What should you compare before buying?

Compare the operating principle against the actual product, pack range, sustained good output, measurable quality limits, cleaning, changeover and site conditions. Use representative samples and agree what will be demonstrated during testing before delivery and after installation.

Machinery options for this problem

Start with the first option below. It most closely matches the product, pack and problem described on this page. The other options may suit a wider line or a different level of automation.

packagingautomationuk.co.ukView machinery →packaginglines.co.ukView machinery →

Related robotic pick and place questions

Production process relating to robotic pick and placeConveyors, automation and lines

Why is robotic pick and place production giving inconsistent results?

Variation usually begins with changing product or packaging conditions, unstable presentation, unsuitable settings or wear in the process.

See the checks →
Production process relating to robotic pick and placeConveyors, automation and lines

How can I increase robotic pick and place production speed?

Increase sustained good output by identifying the actual constraint, separating machine cycle time from handling time and removing the first recurring cause of waiting.

See the checks →
Production process relating to robotic pick and placeConveyors, automation and lines

Why does robotic pick and place equipment keep jamming or stopping?

Find the first point where control is lost. A downstream alarm is often only the final symptom of poor feeding, transfer, detection or format control.

See the checks →
Questions customers also ask

Useful questions before you compare machinery

Use the questions below to prepare the information needed for a useful recommendation.

What should I check first for feeding and presentation in robotic pick and place?
Provide representative samples. Define required orientation and handover.
Can settings alone solve feeding and presentation?
Sometimes, but settings should only be changed after product, packaging, presentation, wear and utilities have been checked. Change one controlled condition at a time.
What samples are needed for a robotic pick and place machinery trial?
Provide representative product and packaging from normal production, including the hardest size or condition and enough material for setup and sustained testing.
How should performance be accepted?
Use written numerical and visual acceptance limits over a representative run, including output, quality, rejects, interventions and changeover where relevant.
Where can I see machinery for this problem?
Start with packagingautomationuk.co.uk. It is the closest match for the product, pack and problem on this page; the other options may suit a wider line or a different production requirement.